JANE CONCORD MATRIX PLATFORM Mode D'emploi page 23

3 Removing the MATRIX LIGHT 2
baby carrier from the platform
If the baby carrier is facing backwards (position
2), pull the handle (fig. 2e) to release the swivel
(5) and turn to the loading position (position
1 or 3).
3 - Press the catches on the sides of the baby
carrier handle to release the Pro-fix an-
chors and lift the baby carrier.
WARNING
Never leave the child alone.
Any alteration or addition to the device
without due authorisation from JANÉ may
seriously alter the safety of the retention
system.
It can be dangerous for the child's safety if
the instructions for the correct use of the
retention system are not followed carefully.
This safety device must not be used without
its upholstery, or with different upholstery
that is not the original one, as it forms part
of the safety characteristics of the system.
Check that the seat has been installed
correctly.
Check the road traffic regulations in the
country where you are travelling. The use
of your child restraint system may be res-
tricted.
RECOMMENDATIONS
Keep this instruction manual for future re-
ference. Always keep it in the compartment
on the frame (9).
Make sure that any luggage or other ob-
jects inside the car that could cause harm in
the event of an accident are properly secu-
red or stored away.
The platform should be secured with the
ISOfix fasteners, even when not in use, as in
the event of an accident it could move and
injure the other occupants of the vehicle.
Remember not to use the Platform in cars
fitted with a frontal airbag, unless this can
first be disconnected or deactivated, if in
doubt consult the vehicle manufacturer or
dealership.
23