Vaude Power Odyssee 2P Mode D'emploi page 18

5. Starting from this central reinforced triangle fasten
the clamping hooks to the poles. Do not yet close
the red clamping brackets so that the tent can still
be adjusted to align with the poles.
6. Now guide the short poles into the front of the tent
on both sides between the two double hooks and
fix the ends again below on the square kooks (C).
Note: if it's not possible to guide the poles between
the two hooks loosen one hook and close it again
afterwards.
7. The tent should now stand unaided. Anchor the
tent with the woven ribbons and the clamping
hooks at all 6 corners of the tent with a peg.
8. Now anchor the porch and if necessary the guy
lines with tent pegs. To stabilize the tent in strong
winds up to storms you can fix the hooks with
clamping brackets on the poles. This ensures the
tent is extremely wind stable (d).
9. To provide enough air flow please open the variable
entrances.
TaKe down – general insTrUCTions:
• Remove everything from the tent's interior.
• Freestanding tents can be gently shaken out to
remove leaves, sand, and other debris.
• Turn the tent over with floor facing upward and
allow it to dry a bit longer.
• If it's not possible to dry the tent completely before
packing it, this should be done within 12 hours to
prevent the risk of mold and mildew growth.
• As in the tent set up, never pull the poles out of the
pole sleeves; rather push them through.
• When storing a tent in its stuff sack, make sure that
stakes and poles don't press against the tent fabric
and damage it.
• Before taking down your tent, close all zips and
roll up the guy lines. That way you won't have to
untangle them when it comes time to set the tent
up again, and pitching is that much easier.
disManTling – "Model­sPeCifiC":
1. Remove the pegs from the base points and the
hooks from the poles, thus let the tent fold in on
ENGLISH
11