Ayce PRT2643B1 Traduction De La Notice Originale page 51

H1 H2
H4 H5
Extending the cutting line
WARNING: Do not use any kind of metal wire or metal wire encased in plastic in the
cutting head. This may cause serious injuries to the user.
Your machine is equipped with tap automatics with double string. it means that
both strings will be extended when the cutting head touches the ground and the
machines runs on full grass.
1. Hold the machine in operation over the grass area and slightly touch the
ground with cutting head several times. In this way you extend the string
2. The knife in the protection guard cuts the string to required length.
1. Hold the machine in operation over the grass area and slightly touch the
ground with cutting head several times. In this way you extend the string
2. The knife in the protection guard cuts the string to required length.
Stopping the engine
1. Reduce the engine speed and let it run with no load for a few minutes.
2. Switch off the engine by moving the engine switch to the stop position.
The accessory may cause an accident if it continues to turn after the engine has
stopped or after the engine switch has been released. When the unit has stopped,
check carefully that the accessory has stopped turning before putting the unit down.
H3
H6
MAINTENANCE
Good maintenance is essential for safe, economical and trouble-free operation. It will
also help reduce air pollution.
The purpose of the maintenance and adjustment schedule is to keep the
machine in the best operating condition.
Turn off the engine before performing any maintenance. If the engine must be run,
make sure the area is well ventilated. The exhaust contains poisonous carbon
monoxide gas
Please always select recommended accessories. The accessories which have not
equivalent quality may damage the machine.
Please never use non approved components and remove the safety devices
after or during maintenance.
Maintenance
Clean the outside of the machine.
Make sure the throttle trigger lock and the
throttle function correctly from a safety
point of view.
Check that the engine switch works
correctly.
Check that the blades do not move when the
engine is idling or when the choke is in the
start throttle position.
Check that the blades are undamaged and
show no signs of cracking or other damage.
Replace the blades if necessary.
Check that the blade guard is not damaged
or distorted. Replace the blade guard if it is
bent or damaged.
Clean the air filter. Replace if necessary.
Check that nuts and screws are tight.
100 101 GB
Daily Weekly Monthly
maintenance maintenance maintenance
X
X
X
X
X
X
X
X