Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
z)
Keep always correct working posture, have frequently rest periods and change
working positions. Keep firm footing and balance during operation, use the
harness provided.
Maintenance and storage
a)
Keep all nuts and screws tight to be sure the equipment is in safe working
condition.
b)
Never store the equipment with petrol in the tank inside a building where fumes
can reach an open flame or spark.
c)
Allow the engine to cool before storing in any enclosure.
d)
To reduce the fire hazard, keep the engine, silencer and petrol storage area free of
vegetative material and excessive grease.
e)
Replace worn or damaged parts for safety.
f)
If the fuel tank has to be drained, this should be done outdoors.
g)
Always clean and maintenance before storage.
h)
Never disassembly the guards for cutting attachments.
i)
Always store the metal blade in cool and dry place, never use rusted blade. It may
cause serous injure during working.
TRANSPORTATION AND HANDLING
c)
Whenever the machine is to be handled or transported you must:
−
turn off the engine, wait for the cutting device to stop and disconnect the
spark plug cap;
−
fit the cutting device guard;
−
use protective gloves when handling the blades;
−
Keep the blade protection device on;
−
only hold the machine using the handgrips and position the cutting device in
the opposite direction to that used during operation.
d)
when using a vehicle to transport the machine, position it so that it can cause no
danger to persons and fasten it firmly in place to avoid it from tipping over, which
may cause damage or fuel spillage.
INTENDED USE
This unit is designed to be used in accordance with the descriptions and safety
instructions indicated in this operating manual.
-
for private use;
-
for trimming lawn edges and small inaccessible areas of grass
(e.g. under bushes);
-
for cutting wild growth, shrubs and undergrowth.
It is not permitted to use this unit for any other purposes.
The user is liable for all injuries to third parties and damage to their property.
Operate the unit only in the technical condition as stipulated and delivered by the
manufacturer. Arbitrary changes to the unit will exclude the manufacturer from
any liability for resulting injury and/or damage.
Assembly
WARNING! Please ensure that the grass trimmer is switched off properly and
that the engine has stopped completely before assembly and adjustment.
Assembly of t h e h a n d l e (Fig.1-1, 1-2, 1-3)
1.
Remove the screws from the handle
2.
Place the handle in position and assembly the front cover.
3.
Assembly and tighten the screw.
CAUTION!
Do not tighten the screws until you have set the handle in optimal working position.
Please always adjust the handle position with full assembled accessories.
Fig.1-1
Fig.1-2
Assembly the guard (Fig.1-4 Fig.1-5)
1.
Loosen the screw on the fixed guard
2.
Place the guard on the fixture.
3.
Assembly and tighten the screws.
Fig.1-5
Fig.1-4
DIVISIBLE SHAFT ASSEMBLY (Fig.1-6, 1-7)
1.
Loosen the wing nut on top of the shaft (Fig. 1-6).
2.
Slide the bottom part of the shaft into the grip the top.
3.
The holding pin on the bottom part must visibly engage (Fig.1-7).
4.
Tighten the wing nut.
WARNING! Before starting the machine, ensure that both shaft parts fit tightly
together and wing nut is sufficiently tightened.
94 95
GB
Fig.1-3
Publicité
Table des Matières
