Safety Instructions For Maintenance - Husqvarna PP 70 Manuel D'utilisation

To do a check of the machine stop button
1. Turn the machine stop button on the product to
make sure it is disengaged (A).
A
B
2. Start the connected power tool.
3. Push the machine stop button and make sure that
the connected power tool stops.
RCD
The product has an integrated RCD. The RCD is a
protection for the operator if an electrical fault occur.
To do a check of the RCD
1. Start the product, refer to
page 9 .
2. Look into the inspection holes and push the RCD
test button.
1244 - 002 -
To start the product on
3. Make sure that the RCD moves and that it
disconnects the product from the power supply.
4. Turn the RCD reset knob to reset the RCD.

Safety instructions for maintenance

WARNING: Read the warning instructions
that follow before you do maintenance on
the product.
• Not approved changes and/or accessories can
cause serious injury or death to the operator or
others.
• Do the daily maintenance to make sure that the
product operates correctly. Refer to
page 10 .
• Do the inspection and/or maintenance with the motor
stopped and the power plug disconnected.
• Clean the product with water. Do not use high
pressure washer. Do not point the water at electrical
components or bearings.
• All repairs must be done by an approved service
person. Use only Husqvarna or equivalent
replacement parts.
Maintenance on
7