Aim TTi TG1000 Manuel D'instructions page 5

DC Offset Accuracy:
Resolution:
Pulse Aberrations:
Aux Out
Multifunction output user definable or automatically selected to be any of the following:
Waveform Sync:
Trigger:
Sweep Sync:
Output Signal Level:
INPUTS
Ext Trig /Gate
Frequency Range:
Signal Range:
Minimum Pulse Width:
Input Impedance:
VCA In
Frequency Range:
Signal Range:
Input Impedance:
INTERFACES (TG2000 only)
RS-232:
USB:
GENERAL
Display:
Data Entry:
Stored Settings:
Size:
Weight:
Power:
Operating Range:
Storage Range:
Environmental:
Safety & EMC:
4
typically ±3% ±10mV, unattenuated.
3 digits for both Amplitude and DC Offset.
<5% + 2mV.
A square wave at the main waveform frequency. Symmetry is 50% for
sine and triangle waves at MAIN OUT; for square waves and pulses
symmetry is the same as that of the waveform at MAIN OUT.
Outputs a replica of the current trigger signal.
Outputs a trigger signal at the start of sweep to synchronize an
oscilloscope. Can additionally output a sweep marker.
Output impedance 50Ω nominal. Logic levels of <0.8V & >3V, except
for Sweep Sync. Sweep Sync is a 3-level waveform: low at start of
sweep, high for the duration of the last frequency step at end of sweep,
with a narrow 1V pulse at the marker point.
DC - 1MHz for FSK; DC – 100kHz for Gate; DC – 2.5kHz for Tone and
Sweep.
Threshold nominally TTL level; maximum input ±10V.
100ns for Gate and FSK modes; 0.2ms for Sweep and Tone modes.
10kΩ
DC - 100kHz.
2.5V for 100% level change at maximum output.
typically 6kΩ.
Variable Baud rate, 19200 Baud maximum. 9-pin D-connector.
As well as operating in a conventional RS-232 mode the interface can
be operated in addressable mode whereby up to 32 instruments can be
addressed from one RS-232 port.
Standard USB hardware connection.
20 character x 4 row alphanumeric LCD.
Keyboard selection of mode, waveform etc.; value entry direct by
numeric keys or by rotary control.
Up to 9 complete instrument set-ups may be stored and recalled from
non-volatile memory.
260(W) x 88(H) x 235(D)
2kg. (4.5lb.)
110-120V AC or 220V-240V AC ±10%, 50/60Hz,
adjustable internally; 35VA max. Installation Category II.
+5°C to 40°C, 20-80% RH.
-20°C to + 60°C.
Indoor use at altitudes up to 2000m, Pollution Degree 2.
Complies with EN61010-1 & EN61326-1.
For details, request the EU Declaration of Conformity for this instrument
via http://www.aimtti.com/support (serial no. needed).