Aim TTi TG1000 Manuel D'instructions page 4

Gated
Non-phase coherent gating - output carrier wave is on while Gate signal is high and off while low.
Carrier frequency:
Carrier waveforms:
Trigger rep. rate:
Gate signal source:
Sweep
Carrier Waveforms:
Sweep Mode:
Sweep Width:
Sweep Time:
Marker:
Sweep Trigger Source:
External Amplitude Modulation
Carrier Frequency:
Carrier Waveforms:
Modulation Source:
Frequency Shift Keying (FSK)
Phase coherent switching between two selected frequencies at a rate defined by the switching
signal source.
Carrier frequency:
Carrier waveforms:
Switch repetition rate:
Switching signal source: Manual (front panel MAN TRIG key), internal trigger generator, external
Tone
The tone is output while the trigger signal is high and stopped while the trigger signal is low. The
next tone is output when the trigger signal is high again.
Carrier Waveforms:
Frequency List:
Switching Source:
Min Switching Time:
OUTPUTS
Main Output
Output Impedance:
Amplitude:
Amplitude Accuracy:
Amplitude Flatness:
DC Offset Range:
From 1mHz to 20MHz [10MHz].
All
DC to 100 kHz external; to 5kHz using internal trigger generator.
Manual (front panel MAN TRIG key), external signal (TRIG/GATE IN),
internal gate generator or remote interface.
All
Linear or logarithmic, single or continuous.
From 0.2Hz to 20MHz [10MHz] in one range. Phase continuous.
Independent setting of the start and stop frequency.
50ms to 999s (3 digit resolution).
Available from AUX output. Variable during sweep.
The sweep may be free run or triggered from any of the following
sources: Manual (front panel MAN TRIG key), external from TRIG/GATE
IN or from remote interface.
From 1mHz to 20MHz [10MHz].
All
VCA IN socket
From 1Hz to 20MHz [10MHz].
All
DC to 5kHz (internal trigger) or DC to 1MHz (external trigger).
signal (TRIG/GATE IN) or remote interface.
All
Up to 16 frequencies from 1Hz to 20MHz
Manual (front panel MAN TRIG key), internal trigger generator, external
signal (TRIG/GATE IN) or remote interface.
1ms per tone
50Ω or 600Ω
5mV to 20V pk-pk open circuit, (2.5mV to 10V pk-pk into 50Ω/600Ω).
Output can be specified as HiZ (open circuit value) or V (voltage into
characteristic impedance) in pk-pk, r.m.s. or dBm.
±3% ±1mV at 1kHz into 50Ω/600Ω.
±0.2dB to 500kHz; ±2dB to 20MHz [±1dB to 10MHz].
±10V. DC offset plus signal peak limited to ±10V from 50Ω/600Ω.
[10MHz]
3