Care And Cleaning; Troubleshooting Guide - Kenwood BLP31 Manuel D'instructions

Care and cleaning

Refer to Illustration
cleaning information.
Always switch off, unplug and
dismantle before cleaning.
Empty the goblet before
unscrewing it from the blade
unit.
Do not immerse the blade unit
in water.
Power unit
Wipe with a damp cloth, then
dry.
Do not immerse the power
unit in water.
Store excess cord in the
storage area on the underside
of the power unit.

Troubleshooting guide

Problem
The appliance will
not operate.
Blender, Blend
-Xtract 2Go or muti
mill leaking from
blade assembly.
Seal missing from
blade unit when
removed from
packaging.
Poor blending
performance.
If none of the above solve the problem see 'Service and Customer
Care'.
G
for
Cause
No Power.
Blender, Blend
-Xtract 2Go or mill
not assembled or
fitted to power
unit correctly
Seal missing.
Seal incorrectly
fitted.
Seal damaged.
The seal is packed
pre-fitted to the
blade unit.
Mix being
processed
too thick or
insufficient liquid
added.
Quantity being
processed too
small.
7
Blender and Multi Mill blade
assembly
Remove the blade unit from
the goblet or mill by turning
to the unlock position
release.
Grinding and grating mills
Remove the lid from the blade
assembly by turning in a
clockwise direction.
1 Blender/multi mill: remove
and wash the sealing ring.
2 Do not touch the sharp blades
– brush them clean using
hot soapy water, then rinse
thoroughly under the tap. Do
not immerse the blade unit in
water.
3 Leave to dry upside down.
Solution
Check blender plugged
in.
Check blade assembly
is fully tightened and
locked onto the power
unit.
Check seal is fitted
correctly and not
damaged. To obtain a
replacement seal see
'Service and Customer
Care'.
Unscrew goblet/bottle/
mill jar and check that
seal is fitted to blade
unit.
To obtain a replacement
seal see 'Service and
Customer Care'.
Scrape mix down and
add additional liquid.
Trying pulsing first to
start the mixing process.
Do not fill below the
minimum capacity
marking on the goblet.
to