Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

IMPORTANT INSTRUCTIONS -
Models: AK80LS, AK110LS, AK80LS6,
AK90LS6, AK100LS6, AK110LS6
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED.
PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
electric shock and injury to person, including the following:
CAUTION:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK
AND INJURY TO PERSON, OBSERVE THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer.If
you have questions, contact the manufacturer.
b) Before servicing or cleaning the unit, switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
CAUTION:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK
AND INJURY TO PERSON, OBSERVE THE FOLLOWING:
a) Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-related construction.
b) Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equipment
to prevent back drafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA)
and the American Society for Heating, Refrigeration, and Air
Conditioning Engineers (ASHRAE), and the local code authorities.
c) When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
A210952008 Rev. F 5-14
OPERATING MANUAL
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precautions
should always be followed to reduce the risk of fire,
SAVE THESE INSTRUCTIONS
d) Ducted fans must always be vented to the outdoors.
e) If this unit is to be installed over a tub or shower, it must be
marked as appropriate for the application and be connected to a
GFCI (Ground Fault Circuit Interrupter) - protected branch circuit.
f) This unit must be grounded.
g) To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off power unit.
h) Suitable for use with electronic speed control device.
CAUTION:
USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS AND
VAPORS.
WARNING:
i) Read all instructions before installing or using exhaust fan.
www.airkinglimited.com
Exhaust Fan
FOR GENERAL VENTILATING USE ONLY. DO NOT
DO NOT USE IN KITCHENS.
1 of 8

Publicité

Table des Matières
loading

Sommaire des Matières pour AirKing AK80LS

  • Page 1 IMPORTANT INSTRUCTIONS - OPERATING MANUAL Models: AK80LS, AK110LS, AK80LS6, Exhaust Fan AK90LS6, AK100LS6, AK110LS6 READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
  • Page 2 ALL DUCTING MUST COMPLY WITH LOCAL AND NATIONAL BUILDING CODES. SECTION 1 Connect the proper size ducting (AK80LS, AK110LS - 4" round, AK80LS6, Preparing the Exhaust Fan AK90LS6, AK100LS6, AK110LS6 - 6" round) to the fan’s duct collar (Figure 4).
  • Page 3: Completing The Installation

    NOTE: If the fan motor plug is connected to the fan housing receptacle, unplug so 3b. AKLS6 MODELS: Plug the fan’s 5 pin quick connect motor cord into the the blower assembly can be completely removed. included harness. Plug the 3 pin quick connect harness cord into the receptacle located on top of the wire compartment.
  • Page 4: Troubleshooting Guide

    Blower Assembly 5S2202013 Grill Springs 5S1202047 Grill 5S1202005 Internal Wire Cover - AKLS 5S1202004 Motor Cap Harness - AK80LS 5S2202007 Motor Cap Harness - AK110LS 5S2202010 Wire Cover Assembly - AKLS6 5S1202052 Motor Cap Harness - AK80LS6 5S9202502 Motor Cap Harness - AK90LS6...
  • Page 5: Ventilateur D'évacuation

    INSTRUCTIONS IMPORTANTES – MODE D’EMPLOI Modéles : AK80LS, AK110LS, AK80LS6, Ventilateur d’Évacuation AK90LS6, AK100LS6, AK110LS6 LIRE ET CONSERVER CES INSTRUCTIONS LIRE SOIGNEUSEMENT AVANT DE TENTER D’ASSEMBLER, INSTALLER, OPÉRER OU DE RÉPARER LE PRODUIT DÉCRIT. PROTÉGEZ VOUS-MÊME ET LES AUTRES EN OBSERVANT TOUTE L’INFORMATION DE SÉCURITÉ. FAILLIR À SE CONFORMER AUX INSTRUCTIONS PEUT RÉSULTER EN BLESSURE PERSONNELLE GRAVE ET/OU EN DOMMAGE À...
  • Page 6 TOUS LES CONDUITS DOIVENT ÊTRE CONFORMES AUX CODES DU BÂTIMENT LOCAUX ET NATIONAUX. SECTION 1 Branchez la canalisation de grandeur appropriée (AK80LS, AK110LS – Préparation du Ventilateur d’évacuation circulaire de 4", AK80LS6, AK90LS6, AK100LS6, AK110LS6 – circulaire de 6") Sortir le ventilateur de sa boite et confirmer que toutes les pièces sont au collet du conduit du ventilateur (Figure 4).
  • Page 7: Couvercle Du Compartiment De Câblage

    REMARQUE : Si le raccord du moteur de ventilateur est raccordé au réceptacle du châssis, le débrancher afin que l’ensemble venturi du ventilateur soit complètement enlevé. Couvercle du Compartiment de Câblage Figure 9 2b. MODÈLES AKLS6 : Branchez le cordon du moteur du ventilateur à 2 broches Figure 7 de connexion rapide du moteur dans le câblage inclus.
  • Page 8: Guide De Dépannage

    Ressorts de la grille 5S1202047 Grille 5S1202005 Couvercle de Câble Interne - AKLS 5S1202004 Harnais du Capuchon du Moteur - AK80LS 5S2202007 Harnais du Capuchon du Moteur - AK110LS 5S2202010 Assemblée du compartiment du fil - AKLS6 5S1202052 Harnais du Capuchon du Moteur- AK80LS6...

Ce manuel est également adapté pour:

Ak110lsAk80ls6Ak90ls6Ak100ls6Ak110ls6

Table des Matières