Trouble Shooting - Tecsun PL-660 Manuel D'utilisation

QUESTIONS
Can not turn on the radio.
Radio turn off while
listening.
During ATS, some station
cannot be stored.
Some stored station with
noise.
Only limited FM stations
can be received.
Poor AM reception in
USA.
The sound of SW SSB
broadcasting is too low.
When the alarm is on,
there is only noise with
the broadcast.

TROUBLE SHOOTING

ANSWERS
- Batteries have no power
- Installing batteries
incorrectly
- Key knob function is
being activated.
- Batteries have no power
- Sleep timer is being
activated.
- Frequency of stations are
too weak.
- There is interference near
by your area.
- FM frequency might be
set as 76~90 MHz
accidentally.
- USA is using 10 kHz AM
tuning step not 9 kHz.
The default bandwidth is
Narrow band.
- Did not set the proper
radio station for the alarm.
- Or there is no
broadcasting at that radio
station.
- Or you are in another city
where does not have a
radio station for your
preset frequency.
www.tecsunradios.com.au
SOLUTIONS
- Replace all batteries with
new one.
- Observing the polarities of
battery, then re-install all
batteries again.
- Press the [ ] button to
deactivated it.
- Replace all batteries.
- Turn on the radio again.
- Search the station manually
- Low down the antenna or
move to other location and try
again.
- Turn off the radio, press &
hold the [FM SET] button to
select the accurate FM
frequency range.
- Turn off the radio press the
[9/10kHz] button to select
accurate tuning step.
Press the [AM BW] button to
select the Wide band.
- Preset your alarm station
properly
- Make sure it has radio
broadcast in your location.
-- 27 --
.