Method 3: Ats (Auto Tuning Storage); Fm Ats; Mw/Lw Ats; Sw Ats - Tecsun PL-660 Manuel D'utilisation

WORKING WITH STATION MEMORIES

METHOD 3: ATS (AUTO TUNING STORAGE)

FM ATS:

1. Fully extend the telescopic antenna and
press the [FM] button to select FM
band.
2. Press & hold the [FM] button with
"PRESET" flashing and the
frequency start running, then you can
scan and store the available stations
within the memories. When the
frequency stop running, it means the
ATS operation has been completed;
you can rotate the [TUNING] knob
searching for those scanned and stored
stations.

MW/LW ATS:

1. Press the [AM] button to select MW/LW band.
2. Press & hold the [AM] button for ATS MW or LW.

SW ATS:

Fully extend the telescopic antenna and press the SW [
SW band. There are two modes for SW ATS tuning:
Mode A: Press & hold the [
Press & hold the [
Mode B:
band only.
Notes:
1. During ATS process in FM, MW / LW or SW (mode A), pre-stored radio stations
will be replaced automatically by the new searched stations.
2. With ATS in SW (mode B), those existing memories will not be replaced; all the
newly found radio stations would be stored in the blank memories addresses.
3. If there is too many interference in you surrounding or many mirror/blank station
being stored during ATS, you should contract the telescopic antenna (FM & SW)
or rotate the radio (MW & LW) for better location. You can also push the [ANT.
GAIN] button to the position "NORMAL" or "LOCAL" to restart ATS.
-- 14 --
.
] button to ATS the stations within all meter bands
] button to ATS the stations within present meter
www.tecsunradios.com.au
] or [ ] button to select