Checklist; For Your Reference - Panasonic PV-20DF64-K Mode D'emploi

Check List
Turn down the volume, then turn this unit, as
well as other equipment to be connected, off
before pro ceed ing with connection.
Do not block ventilation holes of any equipment
and arrange it so that air can circulate freely.
Enjoying digital audio output from the
digital audio output con nec tor
Notes on audio output from the optical
digital audio output con nec tor
Sound
Optical digital audio
Disc recording
output from connector
format
Dolby Digital bitstream
Dolby Digital (1-5.1 ch) or PCM (48 kHz
sampling/16 bit only)*
Linear PCM Linear PCM (2ch)
DVD-V
(48/96 kHz (48 kHz sampling/16 bit
16/20/24 bit) only)*
Bitstream or PCM (48 kHz
dts
sampling/16 bit only)*
Dolby Digital bitstream
Dolby Digital (1-5.1 ch) or PCM (48 kHz
sampling/16 bit only)*
DVD-RAM
Linear PCM
(48 kHz Linear PCM (2ch)
16 bit)
Linear PCM
CD
Linear PCM
(44.1 kHz sampling)
1
* The type of audio output from the connector can
be selected by adjusting the Settings for DVD
Operation. (See pages 56-57.)
2
* When "LPCM" is set to OFF in the DVD Main
Menu, only 48 kHz sampling/16 bit is output.
When set to ON, sampling of sound quality
greater than 48 kHz/16 bit is reduced to
48 kHz/16 bit. (See pages 56-57.)
Manufactured under license from Digital
Theatre Systems, Inc. US Pat. No's.
5,451,942, 5,956,674, 5,974,380,
5,978,762, 6,487,535 and other U.S. and
world-wide patents issued and pending.
"DTS" and "DTS 2.0 + Digital Out" are
trademarks of Digital Theatre Systems,
Inc. Copyright 1996, 2003 Digital Theatre
Systems, Inc. All Rights Reserved.
Manufactured under license from Dolby
Laboratories. "Dolby," "Pro Logic," and the
double-D symbol are trademarks of Dolby
Laboratories.
All manuals and user guides at all-guides.com

For your reference:

• Dolby Digital is a digital sound compression
• Linear PCM is a signal recording format used in
• If you have a Dolby Pro Logic Surround decoder,
1
2
IMPORTANT NOTE:
Caution for optical digital audio output
1
connector:
• When connecting an amplifier (with an optical
1
• Be sure to refer to pages 56-57 regarding output
• CDs can be played as usual.
• Some dts decoders which do not support
technique developed by the Dolby Laboratories
Licensing Corporation. Supporting 5.1-channel
surround sound, as well as stereo (2-channel)
sound, this technique enables a large quantity of
sound data to be efficiently recorded on a disc.
CDs. While CDs are recorded in 44.1 kHz/16 bit,
DVDs are recorded in 48 kHz/16 bit up to
96 kHz/24 bit.
you will obtain the full benefit of Pro Logic from
the same DVD movies that provide full 5.1
channel Dolby Digital soundtracks, as well as
from titles with the Dolby Surround mark. For
information on Panasonic Dolby Pro Logic
Surround Sound Decoders please contact your
local dealer.
digital input connector) which does not contain
the Dolby Digital or dts decoder, be sure to
select "PCM" at "Dolby Digital" and "PCM" at "dts"
in the Settings for DVD Operation "Selecting
AUDIO OUTPUT" (see pages 56-57). Otherwise,
any attempt to play DVDs may cause such a high
level of noise that it may be harmful to your ears
and damage your speakers.
settings of Dolby Digital, dts, and PCM.
Note
DVD-dts Interface may not work properly with
the unit.
17