ABB 6996 Instructions De Montage page 41

Programming
1.1.1.20
Programming:
Only control chip 6997/60-500 is programmed via ETS
2 as of version 1.3 or via Power Project as of version
4.0.
1. Connect a PC with the appropriate software via EIB-
RS232 interface to the Powernet EIB bus line.
2. Switch on the mains supply and press the
programming pushbutton (Fig. 3). The red LED goes
on.
3. After the physical address has been programmed, the
LED goes off again.
4. Write the physical address on the device using a
smudge-proof pen.
5. Please refer to the current technical manual for
information on the available application versions and
the associated parameters.