ABB 6996 Instructions De Montage page 40

Addressing of the switching / shutter
actuators
1.1.1.19
Address assignment
• Pressing pushbutton 1 in the programming mode will
increase the module address by 1. This means: Pressing
once = address 1, pressing twice = address 2, etc.
• Set the desired address by pressing pushbutton 1 in the
programming mode (see above).
• If you do not press a pushbutton within 5 seconds, the
device automatically leaves the programming mode and
takes over the address set at last.
Hint
When several modules are connected to one data
output, multiple use of the addresses is permissible for
the same module types. These modules will then be
controlled in parallel.
Programming can be corrected at any time after it has
been finished.