General Safety; Grounding Instructions - Campbell Hausfeld HousePainter EZ5000 Serie Instructions De Fonctionnement

Operating Instructions & Parts Manual

General Safety

Caution indicates
CAUTION
!
a potentially haz-
ardous situation which, if not avoided,
MAY result in minor or moderate
injury.
Notice indicates
NOTICE
important infor-
mation that, if not followed, may
cause damage to the equipment.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS – To
reduce the risk of fire or explosion,
electrical shock and injury to per-
sons, read and understand all
instructions included in this manual.
Be familiar with the controls and
the proper usage of the equipment.
DANGER
!
ELECTRICAL SHOCK HAZARD:
To prevent electrical shock,
observe the following guide-
lines at all times:

GROUNDING INSTRUCTIONS

This product must be grounded. In
the event of an electrical short cir-
cuit, grounding reduces the risk of
electric shock by providing an
escape wire for the electric current.
This product is equipped with a cord
having a grounding wire with an
appropriate grounding plug. The
plug must be plugged into an outlet
that is properly installed and
grounded in accordance with all
local codes and ordinances, as well
as the National Electrical Code (NEC)
Table 1 – Extension Cords for 120V/15 Amp Unit
Length of Cord (ft.) 25-50
Gauge of Cord
www.chpower.com
and, in the United States, the
(Cont.)
Occupational Safety and Health Act
(OSHA).
WARNING
!
grounding plug is liable to result in
a risk of electric shock. When repair
or replacement of the cord or plug is
required, do not connect the
grounding wire to either flat blade
terminal. The wire with insulation
having an outer surface that is
green,with or without yellow
stripes, is the grounding wire.
Check with a qualified electrician or
serviceman when the grounding
instructions are not completely
understood, or when in doubt as to
whether the product is properly
grounded. Do not modify the plug
provided; if it does not fit the out-
let, have the proper outlet installed
by a qualified electrician.
This product is for use on a nominal
120-V circuit and has a grounding
plug similar to the plug illustrated
in Figure 1. Only connect the prod-
uct to an outlet having the same
configuration as the plug. Do not
use an adapter with this product.
Figure 1 - Grounded three-wire
extension cord
50<100 100<150 150<250 250<400 400-500
18 16 14
2
Improper installa
tion of the
TEST RESET
12 10 8