Campbell Hausfeld HousePainter EZ5000 Serie Instructions De Fonctionnement page 4

Operating Instructions & Parts Manual
General Safety
To reduce the risk
WARNING
!
of skin injection:
• Do not aim the gun at or spray
any person or animal.
• Keep hands and other body
parts away from the discharge. Do
not try to stop leaks with any part
of the body.
• Always use the nozzle tip guard.
Do not spray without nozzle tip
guard in place.
• Only use a nozzle tip specified
by the manufacturer.
• Use caution when cleaning and
changing nozzle tips. If the nozzle
tip clogs while spraying:
Q engage the trigger lock (see
Figure 2)
Figure 2 - Engage trigger lock by
rotating lock as shown
Q turn tip insert handle to the
clean position (see Figure 3)
Q disengage
the trigger
lock and pull
the trigge.
Q engage the
trigger lock
Figure 3 - Turn
and turn the
tip insert handle
to clean position
www.chpower.com
tip insert handle back to the
(Cont.)
spray position
Q release the trigger lock and
continue spraying
• Do not leave the unit energized
or under pressure while unattend-
ed. When not in
use, turn the
unit Off (see
Figure 4) and
relieve pressure
by triggering
the gun in a safe
direction. Then
engage the trig-
ger lock.
• High-pressure spray can inject
toxins into the body and cause
serious bodily injury. In the event
that injection occurs, seek medical
attention immediately.
• Check hoses and parts for signs
of damage. Replace any damaged
hoses or parts.
• This system is capable of produc-
ing 3000 psi. Only use replace-
ment parts or accessories that are
specified by the manufacturer and
rated at a minimum of 3000 psi.
• Always engage the trigger lock
when not spraying (see Figure 2).
Verify the trigger lock is function-
ing properly by pulling the trig-
ger. If the trigger lock is function-
ing properly the gun valve will
not spray.
• Verify that all connections are
secure before operating the unit.
• Know how to stop the unit and
bleed pressure quickly. To bleed
pressure quickly either
4
Figure 4 - Icon
showing Off
position