Campbell Hausfeld HousePainter EZ5000 Serie Instructions De Fonctionnement page 9

Step 2 – Using Your
HousePainter
much as possible. If you still have
'tails' at the highest pressure setting,
or if you have any other pattern prob-
lems, please see the suggestions in the
Troubleshooting chart beginning on
page 13.
Holding Spray Gun
Heavy
Thin Coat
Coat
Over-
spray
Result of Flexing Wrist While Spraying
Approx.
10-12"
Pull
Trigger
Start
Stroke
Proper Way to Trigger Spray Gun
Spraying
Position yourself so the spray tip is
(Cont.)
10" – 12" from the surface being
sprayed. It is important to keep your
knuckles pointed at that surface to
make sure you only spray the intended
surface.
Begin moving the gun, then pull the
trigger. Hold the trigger throughout a
comfortable range of motion and
12"
release the trigger prior to changing
direction or ending the stroke. In other
words, try not to activate or release
the trigger when your arm is not in
motion. You will get a build up of
paint at any point where the gun is
spraying without your arm being in
motion.
Rolling
If you use either of the roller acces-
sories available, remove the spray tip
Thin Coat
base from the spray gun. Screw the
roller attachment onto the spray gun
(see Figure 10).
Over-
spray Prime the sprayer as described on Page
8. When bubbles are no longer visible
in the bypass tube, turn the One Touch
Control to the Roller icon (see Figure
12). Use the gun trigger to load the
Release
Trigger
End
Stroke
Figure 19 – Paint beginning to dot
roller cover
9
EZ5000 Series
www.chpower.com