Care And Maintenance; Direct Drain Instructions; Storage - Danby Silhouette DDR600R Manuel D'utilisation

Direct Drain Feature:
This dehumidifier is inclusive of a direct drain feature,
located at the lower (left) rear side of the cabinet. NOTE:
The drain hose is not included with the unit. Use a
standard garden hose with standard female connection.
This type of hose can be purchased at any local
hardware store. The direct drain feature is intended for
use in basements inclusive of a floor drain only.
NOTE: Do not attempt to operate the direct drain
feature using drain/stem pipes above ground level.
Fig.3
CONNECTING THE DIRECT DRAIN:
1. Unscrew the drain cap on the direct drain connection.
at the back of the unit.
2. Cut drain hose to required length. (to suit your needs)
Attach garden hose coupler directly onto the direct
drain and tighten.
3. Position the open end of the drain hose directly over
the floor drain and start the unit.
4. Position the dehumidifier as close as you can to the
floor drain.
5. When the direct drain feature is not being used,
remove the drain hose and re-install cap.
All manuals and user guides at all-guides.com
DIRECT DRAIN
(Rear View)

Care and Maintenance

CAUTION: Before attempting to clean and/or service this
unit, always disconnect the power supply cord from the
electrical power supply/outlet.
1. DO NOT use gasoline, benzene, paint thinner, or any
other chemicals to clean this unit, as these substances
will damage/deform both plastic components and
luster finish.
2. Never attempt to clean the unit by pouring water
directly over any of the surface areas, as this will
cause deterioration of electrical components and
wiring insulation.
3. Use only a mild dishwashing detergent, lukewarm
water and a soft cloth to wipe the exterior surface of
the unit and dry throughly.
When the dehumidifier is not being used for long time
periods, please follow these instructions.
1. Disconnect the power cord from the power supply.
2. Empty the water tank and wipe (clean) thoroughly.
3. Clean air filter thoroughly
4. Re-package the unit in the original carton.
5. Store the unit upright in a dry location.
11

Storage