Unpacking And Assembly - THORENS TD 2015 Mode D'emploi

Unpacking and Assembly

Carefully remove the unit and its accessories from the
shipping box.
Supplied items:
1 x plinth (with/without tonearm)
1 x tonearm counterweight
1 x motor in housing
1 x Thorens drive belt
1 x platter with felt mat
1 x electronic control unit PS 800
1 x mains adaptor
1 x power cord
1 x stylus balance
1 x adaptor for single records
3 x protective pads
2 x cotton glove
Attention: The surface of both plinth and platter is
quite sensitive to scratches. It is therefore recom-
mended that you wear the gloves supplied when
assembling the turntable.
24
(only with tonearm)
Proceed by placing the three protective pads where the
turntable is eventually going to be. They are provided
to prevent the sensitive surface of furniture from being
damaged by the turntable's spiked feet.
Now put the feet of the turntable onto the pads and, af-
ter the final position has been achieved, make sure that
the plinth is level. For any fine-adjustments turn the tip of
each foot up or down until the plinth is in a perfect hori-
zontal position. Use a spirit level to check for accuracy.
The motor housing is now inserted into the designated
recess at the rear left corner. This is done by lifting the
plinth and positioning the motor exactly beneath the re-
cess. Lower the plinth slowly so that the motor housing
enters the recess. Great care should be taken while do-
ing this in order to prevent any scratches on the plinth
surface. When in its final position the motor housing
should not touch the inside of the recess.