Placement And Connections - THORENS TD 2015 Mode D'emploi

Placement and Connections

Connect the cord coming from the motor housing to the
rear panel of the electronic control unit PS 800.
Before connecting the turntable to the mains power
please make sure that the power switch on the PS 800
unit is set to OFF and the speed selector switch set to
"33".
➔ Fig. 2.2
The PS 800 unit is connected to the mains by using the
mains adaptor and the power cord plugged into a wall
socket. ➔ Fig. 2.3
Attention: Never disconnect the motor plug from
the PS 800 unit while it is switched ON. Disre-
garding this advice may damage the electronic
circuitry inside the PS 800.
Take the RCA interconnect leads (
them into the designated (phono) input jacks at the rear
side of your amplifier or receiver. Make sure that polarity
(left/right channel!) is correct.
26
➔ Fig. 2.1
) and plug
➔ Fig. 2.4
Fig. 2.1
Fig. 2.3
Fig. 2.2
Fig. 2.4