Settings; Ringer Settings; Flash (Recall) Setting; Receiving Voume And Tone Settings - Geemarc PhotoPHONE 100 Mode D'emploi

Ringer Settings

A switch located on the rear of the PHOTOPHONE 100 unit
allows the ringer volume to be switched
(maximum volume), LO (lowest volume) or OFF (if you would
prefer not to be disturbed).

Flash (Recall) Setting

You can adjust the flash time by using the switch
located on the right side of your telephone phone. There are three
levels available, 100ms, 270ms and 650 ms. Your telephone
works with a flash time for United Kingdom (R=100ms).
Receiving Volume and Tone Settings
You can alter the receiving volume and tone during a
conversation according to your hearing requirements.
Use the Volume slide control
the telephone base to adjust the level. The volume adjustment
available is 0-15dB.
The AMPLIFY button
additional amplification of 15dB i.e the volume adjustment will
become 15-30B. When the amplify function is activated, the
Amplify LED is lit.
Setting a default for Amplification.
The Amplify ON /OFF
amplification facility to be switched ON or OFF as a default each
time you use the telephone.
AMPLIFY ON/OFF Switch at ON Position
The additional amplification and tone controls are automatically
activated each time you use the telephone. The amplify LED light
will be lit when you use the telephone.

SETTINGS

SETTINGS
on the telephone base provides
located at the rear allows the
7
to HI
found at the top of