Operational Advice - KIRAMI Comfort Family Mode D'emploi

Masquer les pouces Voir aussi pour Comfort Family:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 50
30/88
© Kirami Oy, Finland
Grates
Cult stoves come with a cradle fireplace grate where a single wire tray grate is
installed. An air iron plate is placed on the top shelf to direct the circulation of air in
the upper part of the firebox. The plate in the upper part of the stove must not be
pushed too far so that it prevents the exhaust of the smoke.
It is prohibited to use the stove without these parts. Note that these parts wear
down over time and get bent and their form will change in use. You can purchase new
ones as spare parts when needed.
The first use
The water circulation of the stove shall be rinsed by letting plenty of water in from the pipe above,
so that any metal chips from grinding come out. Collect any trash by swiping it off the bottom of the
tub. When you fill the tub, check the fastening pipes of the stove for any leakages.
USE

OPERATIONAL ADVICE

If there is a filter connected to the hot tub. It shall be cleaned and dried if possible whenever the
hot tub is emptied.
No manual dosing of chemicals shall be performed while bathers are present in the hot tub.
It is recommended that the means of access (steps) for hot tub should be away from the chimney to
avoid the user touching the chimney by accident.
Water is to be stirred before measurement to mix the hot surface water with the cooler water
below to prevent false readings. This is to be performed before measuring the temperature and
entering the hot tub the water. Safety check of temperature with bather's elbow is also
recommended just before going into the water.
Monitor the water temperature during bathing so that the heating may be adjusted higher or lower
accordingly. Heating need during the actual bathing depends on the tub and surrounding
temperature and wind conditions.
When filling the tub, note the number of people because people entering the tub will displace the
water when they enter the tub. If there will be many people in the tub, leave the water surface at
the minimum.
In case you are using your own pump for filling the tub, remove the pumping hose after you have
filled the tub. Many pumps do not have a return valve to prevent the water discharge from the tub
when the pumps are switched off. Before filling the tub, check that the bottom plug of the tub is
closed, ensure that the plug is in place after you have some 10 cm of water in the tub.
Family tub has built in stairs to help getting in and out of the tub. This higher part of the stairs can
also be used as a bench fro children during bath.
INSTRUCTIONS FOR USE: Kirami Comfort Family
5 / 11
24.03.2020

Publicité

Table des Matières
loading

Table des Matières