Disposal Method; Ordering Spare Parts - GEMM-SRL UNIVERSAL Série Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

10 – DISPOSAL
10.1 – DISPOSAL METHOD
APPLIANCE STATUS
electronic circuit board in position "O" (OFF);
-
-
power supply plug disconnected from the mains.
METHOD
The appliance is made of ferrous materials, electronic components and plastics. If it needs to be disposed of, separate
the various components according to the material of which they are made, to simplify separate waste collection or re-use
of the parts. The appliance must be disposed of separately from urban waste.
No special instructions apply to the dismantled appliance. Dispose of it through the special operators or return to the
dealer, if the law provides for this (also see "Information to users regarding waste disposal in the European Union"
below).
For disposal consult the laws applicable in the country where the appliance is used (also see "Information to users
regarding waste disposal in the European Union" below).
TAKE
CONTROLLED AND RECOVERED ACCORDING TO THE REGULATIONS OF THE COUNTRY IN
WHICH DISPOSAL WILL TAKE PLACE.
Consult the fitter for any dismantling requirements.
INFORMATION TO USERS REGARDING WASTE DISPOSAL IN THE EUROPEAN UNION
The symbol of a crossed waste bin on the appliance indicates that at the end of its working life the product must be
collected separately from other waste.
Therefore, at the end of the product's working life the user must take it to a suitable centre for the collection of electronic
and electrical waste, or return it to a dealer when purchasing a new appliance of the same type.
Suitable separate waste collection of unwanted appliances and their forwarding to treatment, recovery and
environmentally friendly disposal makes it possible to avoid potential negative effects on the environment and human
health, and assists recycling and recovery of materials.
Unauthorized disposal of the product by the user is punished by the application of fines established by the countries in
which the appliance is disposed of.
11 – SPARE PARTS
11.1 – ORDERING SPARE PARTS
Contact authorized dealer or the manufacturer to order spare parts.
12 – APPENDICES
The appliance comes with the following appendices:
-
Declaration of conformity
-
Electrical diagram
-
Electrical approval report
-
Assessment of vacuum, leakage and gas loading for cooling unit.
TBP – TBPN_TRPE Rev.00-MULTI 04-2014
CARE: THE
APPLIANCE
CONTAINS
REFRIGERANT
GAS
THAT
MUST
pag. 67
BE

Publicité

Table des Matières
loading

Table des Matières