Preparing For Use - GEMM-SRL UNIVERSAL Série Notice D'utilisation

7.4 – CONTROLS
As a whole the appliance is controlled by a digital thermostat.
As soon as the appliance is connected to the electricity supply, the display lights up completely for a lamp test lasting a
few seconds. At the end of the lamp test, the display goes automatically to how it was before the appliance was switched
off, for example if a cycle was in progress at that time, the cycle will restart from the point it was interrupted.
With the PCB OFF, the display is not lit except for the icon . Upon pressing key the icon goes out and the
display comes ON showing the temperature in the cell.
Use the commands on the thermostat, helped by the indications on the display, to activate the various appliance
functions.
If the buzzer sounds for any reason whatsoever, it may be muted by simply pressing any key.
Whatever the status of the appliance, after having activated the keypad, pressing the key puts the PCB to OFF.
7.5 – PREPARING FOR USE
Before using the appliance, the inside of the cell should be thoroughly cleaned.
When switching on after installation or if the appliance has not been used for a long time, it is a good rule to let it operate
empty until the set temperature has been reached.
To get the best performance from the EN refrigerated counter, arrange the stored products so that air can circulate
properly: do not obstruct the refrigerating unit intake, do not lay the food and drinks on top of each other and distribute
the load evenly.
Do not load the appliance with more than the allowed quantities, do not put in food or drinks having a temperature above
the indicated design room temperature and avoid pointlessly opening the door otherwise the efficiency of the refrigerating
unit will be reduced.
TBP – TBPN_TRPE Rev.00-MULTI 04-2014
pag. 60