Installations - Elkron EL50RT 2PH 60m Manuel D'installation

- WIRING DISTANCE
WIRE SIZE
2
0.5 mm
2
1 mm
- CONNECTION SAMPLE
Sample 1
Sample 3

4.0 INSTALLATIONS

The units can be mounted easily on a pole or flat surface.
- Remove cover via screw at base of cover.
- And loosen the unit base mounting screw and remove mounting plate by sliding it against the unit base.
A. Wall mounting
- Pull out the wire through the wiring hole on the mounting plate
and attach the plate to the wall with the screw ( 1/6ªx 3/4ª).
- Connect wire to the terminals.
- After checking optical alignment and operation check, ( please see 7.ALIGNMENT AND OPERATION )
replace the cover, and fasten the cover lock screw tightly.
Note:
12Vdc 24Vdc
250m 2200m
440m 4000m
Power
Alarm signal
Power
Alarm (Ch2)
Alarm (Ch3)
1. When two or more connections is required,
maximum wiring distance is the value above divided
by the number of sets.
2. The power wires could not exceed the above
mentioned lengths.
Sample 2
13/28
Power
Alarm signal
EL50RT 2PH 60m