VELOCIPTOR climb 2 ES 111 OR Manuel De L'utilisateur page 40

HOW TO RECHARGE THE BATTERY
Before first use, charge the battery to 100% capacity.
To make sure you reach your destination, we recommend that you fully
charge the battery when the display shows battery level with 2 bars.
NOTE: the battery must be charged every 30 days, even if the scooter is
not used; if the battery is not charged regularly, it will lose efficiency until
completely discharged; in this case, we cannot acknowledge the warranty
on the product.
Charging procedure
1. Open the charging socket protective cap located on the side of the
scooter and connect the charging plug of the charger, paying attention to
the direction of insertion;
2. Connect the charger to the wall socket at 220V
3. The charging process is in progress with red charger LED light. The
charging process is complete when the charger LED turns green: the
battery is charged to 100% capacity;
4. Disconnect the charger from the wall socket and then the charging socket
from the e-scooter;
5. Carefully close the charger connector with the protective cap.
Always charge the battery in a dry and ventilated environment. Never cover
the charger during charging process, otherwise it may be damaged. The
charger is for indoor use only.
40