VELOCIPTOR climb 2 ES 111 OR Manuel De L'utilisateur page 36

FIRST USE
Display
It is possible to loosen the display fixing bolts on the handlebar, and rotate it, so that
it is clearly readable and the accelerator lever is comfortable and safe for use. Once
the adjustment has been made, properly tighten the nuts.
Brakes
Disc brakes are adjusted at the factory.
a / braking intensity is adjusted by the screw on the brake lever (1) or by the brake
mechanism (2) (3) (4).
b / the pads centering can be adjusted using the screws (4) on the brake
mechanism - gently loosen the bolts, adjust the brake disc so that it is centered
between the pads, then tighten the bolts.
Front light assembly
Before using the scooter it is necessary to mount the front light.
For assembly, proceed as follows:
1. Unscrew and remove the screw in Fig.1 using an Allen key
2. Position the base of the light and tighten it with the screw (Fig.2) tightening firmly
3. Adjust the front lens of the light to the right position and tighten it with a
screwdriver acting on the screw of Fig. 3
1
2
36
3