Keysight Technologies N6700C Serie Guide D'utilisation page 114

Step 4. If you want to generate a pulse train, you must specify the off time between pulses. To do this
you must program another step. For a voltage list, you must specify an amplitude and an off time. For
example, to program an off time of 2 seconds with an amplitude of 0 V between pulses, use:
Front Panel Menu Reference
Select Transient\List\Config.
Select List Step 1 and enter a voltage value of 0. Then
press Select.
Enter a dwell value of 2 for List Step 1. Then press
Select.
Step 5. To generate a pulse train, you can simply repeat the pulse as needed. For example, to
program a pulse train of 50 pulses, use:
Front Panel Menu Reference
Select Transient\List\Repeat.
Enter the number of list repetitions (50). Then press
Select.
Step 6. Specify if you want the output pulse to generate a trigger signal that can be used to trigger
actions on other output channels or on any external equipment connected to the digital port. For
example, to generate a trigger signal at the end of the pulse, use:
Front Panel Menu Reference
Select Transient\List\Config.
Select List Step 0 and enter a value of 1 in the Tout end
step field. Then press Select.
Step 7. Specify the output state after the pulse has completed. For example, to return the output to
the state it was in before the pulse, use:
Front Panel Menu Reference
Select Transient\List\Terminate.
Select Return to start settings. Then press Select.
Step 8. Select the trigger source that will generate the pulse or pulse train.
Select a trigger source from the following:
Bus Selects GPIB device trigger, *TRG, or <GET> (Group Execute Trigger).
l
Imm An immediate trigger command either from the front panel or over the bus will generate an
l
immediate trigger.
Keysight N6700C Series User's Guide
SCPI Command
To program output 1, use
LIST:VOLT 15,0,@1)
LIST:DWEL 1,2,(@1)
SCPI Command
To program output 1, use
LIST:COUN 50,(@1)
SCPI Command
To program a trigger at the End of the pulse for output
1, use
LIST:TOUT:EOST 1,0(@1)
You must program a value of 0 (no trigger) for step 1 as
a placeholder.
SCPI Command
To program output 1, use
LIST:TERM:LAST 0, (@1)
4 Operating the Power System
113