Preparation - Turin Aspen Manuel D'installation, D'utilisation Et D'entretien

7. PREPARATION

If the weight of your range hood is excessive, require three or more people to move and install this range hood.
Body injuries could occur if it is not followed.
Advanced Preparations:
• Be familiar with the controls of the range hood by reading through Range Hood Operation, Page 11.
• Place the range hood on a flat, stable surface. Connect the range hood to a designated standard outlet (please
refer the product label for the suitable voltage of this unit) and turn on the range hood. Verify all operations of
the range hood by referring to Range Hood Operation, Page 11.
• Place all supplied parts and required hardware on a flat, stable surface and verify the existence of all supplied
parts listed on Page 4.
• Carefully remove the white plastic protective coat from the chimney covers and range hood.
CAUTION: To avoid damage to your hood, prevent debris from entering the vent opening.
Preparation:
• Determine and mark the center line on the ceiling where the range hood will be installed. Make sure there is
proper clearance within the ceiling or wall for exhaust vent.
• Due to the weight and size of this unit, please make sure that the support system or framework being used is
stable and secure in the wall.
• Put a thick, protective covering over countertop, cooktop or range to protect from damage or dirt. Remove any
hazardous objects around the area when installing.
• Mark the locations of the support mounting bracket holes, vent cutout (if used) and power supply cable cutout
on the ceiling. Use drill and saber saw or keyhole saw to cut openings for power supply cable and vent (see
Venting Methods and Venting Requirements / Height & Clearances, Pages 5-7).
• Install vent system (see Venting Methods, Page 7). Use caulking to seal exterior wall or roof openings.
• Disconnect main electrical supply, prepare and run electrical wiring through ceiling or wall. Leave approximately
12" of electrical cord hanging from the ceiling. Do not restore power until wiring is completed.
• Disconnect power cord, remove the filter(s) by pressing on the latch.
• Remove the grease cup or gutter (type depends on your model. Turin Milazzo (TU19268) does not have one).
• Set aside the filters and grease cup until the range hood is properly installed.
• If the range hood comes with a glass canopy and has not already been mounted to the hood, loosen the four
canopy screws and washers from the hood top, carefully place the canopy on the hood top, and loosely tighten
the four canopy screws along with washers. DO NOT put excessive pressure against the glass.
9
WARNING