Installation - Turin Aspen Manuel D'installation, D'utilisation Et D'entretien

8. INSTALLATION

Installations (refer to Page 4 for parts):
• Measure the distance between stove top and the bottom of range hood.
• Make sure the range hood is level and not tilted. Mark the locations of the hanging bracket holes on the wall as
shown in emplacements A and B.
• Place the mounting bracket directly above the range hood, level it, and mark the locations of the mounting
bracket holes on the wall.
• Place aside all equipments, locate marked regions and drill holes. Attach range hood to wall using anchors
recommended for your type of wall:
• Sheet rock wall: Attach range hood to stud blockings if possible. If stud blockings are not available, it is
required to build a supporting structure behind the sheet rock for best weight support.
• Concrete wall: Use designated screws (not provided).
• Wood wall: Use at least 4" long wood screws (not provided).
• Fasten two Type "A" anchors (for range hood and for mounting bracket) on the wall.
Loosely fasten two Type "B" screws onto anchors, DO NOT fasten screws all the way.
Hang the range hood on the Type "B" screws and hand tighten them. Leave
approximately 1/16" of gap from the wall to the range hood.
• Place the mounting bracket (or air diverter) against the wall
and align the holes from mounting bracket (or air diverter)
with holes from Type "A" anchors, fasten two Type "B"
screws through the holes onto the anchors. Leave
approximately 1/16" of gap from the wall
to the mounting bracket
• Calculate the height of the duct tube
and extend approximately 6 inches
longer than required, connect the lower
end of the duct tube to the range hood
and the upper end to the vent system.
Make surethe main electrical supply
remains disconnected then connect
power plug to the electrical cord or
wall plug.
• Have one person carefully position both
upper and lower chimneys on the range
hood, let the second person slide the
sides of the chimneys into the 1/16" gap.
Fasten both chimneys with four Type "C" screws.
• Install grease cup and aluminum filters
then check the operation of the range hood..
10
C
B
A
C
A B
C