Electrical Requirements - Turin Aspen Manuel D'installation, D'utilisation Et D'entretien

6. ELECTRICAL REQUIREMENTS

• Contact a qualified electrical installer
• Assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA
70 — latest edition*, or CSA Standards C22. 1-94, Canadian Electrical Code, Part 1 and C22. 2 No. 0- M91- latest
edition** and all local codes and ordinances
• Do not use an extension cord. If the power supply cord is too short, have a qualified electrician install an outlet
near the appliance, in accordance with all applicable codes and standards.
• Turn off electrical power at service entrance before wiring.
If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the
ground path is adequate.
A 120-Volt, 60 Hz, AC-only (USA & Canada standard), fused electrical supply is required on a separate 15-amp circuit,
fused on both sides of the line.
DO NOT ground to a gas pipe.
Check with a qualified electrician if you are not sure that the range hood is properly grounded.
DO NOT have a fuse in the neutral or ground circuit.
IMPORTANT: Save this Installation Guide for electrical inspector's use.
The range hood must be connected with copper wire/plug only.
The range hood should be connected directly to the fused disconnect (or circuit breaker) box through flexible
armored or non-metallic sheathed copper cable. A U.L. - or C.S.A. - listed strain relief must be provided at each end of
the power supply cable.
Wire sizes (copper wire only) and connections must conform with the rating of the appliance as specified on the
model/serial rating label. Wire sizes must conform to the requirements of the National Electrical Code ANSI/NFPA 70 —
latest edition*, or CSA Standards C22. 1-94, Canadian Electrical Code Part 1 and C22. 2 No. 0-M91 - latest edition** and
all local codes and ordinances. A U.L. - or C.S.A. - listed conduit con-nector must be provided at each end of the power
supply cable (at the range hood and at the junction box).
Copies of the standards listed may be obtained from:
* National Fire Protection Association, Batterymarch Park, Quincy, Massachusetts 02269
** CSA International, 8501 East Pleasant Valley Road, Cleveland, Ohio 44131-5575
8
WARNING