Charger Led; Maintenance Instructions; General Maintenance; Storage - TJEP C-RINGER Instructions D'utilisation Et De Sécurité

Charger LED

State of battery charger LED indicator
State Red LED
1 Power on OFF
2 Battery low ON
Battery charged
3 OFF
80%
Battery charged
4 OFF
100%
Battery tempera-
5 ture is too hot or Flashes slowly
too cold
Battery pack
6 ON
malfunction
• Charge the battery at a temperature between 0°C
and +40°C. If the battery pack is too hot or too cold,
the charger will not fast charge and the red indicator
light will be "blinking".
• If both red and green indicator lights are "ON" there
is a battery pack malfunction. Please contact your
TJEP dealer for support.

Maintenance instructions

General maintenance

• The employer and the operator are responsible for
assuring that the tool is kept in safe working order.
• Do not disassemble, modify or repair the tool,
charger, and battery pack.
• Only authorized TJEP service personnel or TJEP
distributors shall repair the tool and must use parts
or accessories that are supplied or recommended
by Kyocera Unimerco Fastening.
• Keep the tool in clean condition at all times. Make
sure that the tool is properly cleaned before lubrica-
tion and maintenance is carried out.
• Please lubricate the tool before first use.
• Never use gasoline or other flammable liquids to
clean the tool.
Green LED
Flashes slowly
OFF
Flashes rapidly
ON
OFF
ON
1. Turn off the main
switch.
2. Press the battery
button and remove
the battery pack.
• NEVER use a tool if there is any doubt.

Storage

• When not in use for an extended period, apply a
thin coat of lubricant to the steel parts to avoid rust.
Do not store the tool in a cold weather environment.
When not in use, the tool should be stored in a
warm and dry place. Keep out of childrens reach.
• Take off the battery pack from main body of the tool
and put them in a plastic bag to avoid dust.
• If the batteries are not in use, they should be fully
charged prior to storing.

Disposal of batteries

Batteries contain substances that can be harmful to
human health and the environment if they are not han-
dled properly. Batteries are marked with the crossed
trash bin. It symbolises that waste batteries must not
be disposed with unsorted waste but must be collected
separately.
It is important that you hand in your waste batteries to
the collection points that are established. In this way,
you help to ensure that the batteries are recycled in
accordance with legislation and do not unnecessarily
damage the environment. Your local waste authorities
can inform you how to dispose and recycle this type of
battery correctly.
English
3. Clean the me-
chanical parts of the
C-ringer by use of an
airgun
4. Add 1-2 drops of
grease, sewing oil
or car motor oil in
the shaft thread and
C-ring groove of jaws
(lubrication points are
marked by arrows).
5. Wipe the tool clean
by using a clean cloth.
9