Operation Instructions; Load C-Rings; Jam Release; Charging The Battery - TJEP C-RINGER Instructions D'utilisation Et De Sécurité

• If the tool is used in an area where there is static
dust, it may spread the dust and cause a hazard.
• Where dust or exhaust hazards are created, the
priority shall be to control them at the point of
emission.
• Avoid dust to be sucked in to the tool when operat-
ing, as it can cause malfunction.

Operation instructions

Load C-rings

7. You are now ready to fasten your work piece.
8
1. Turn off the main
switch.
2. Gently insert the
battery pack.
3. Hold the tool
handle with one hand
and slide C-rings into
magazine with the
other hand.
4. Pull back the pusher
over the strip of C-rings,
by holding both pusher
flaps. Gently release
the pusher to feed the
C-rings to the jaw.
5. Turn on the main
switch.
6. Pull and hold and
release the trigger
once to feed the
C-rings into the
groove of the jaws.

Jam release

Charging the battery

• Supplied batteries are not charged. First time use
requires an initial full charge.
• There are 2 batteries supplied with the tool. It will
take 50 min. before a new battery is fully charged.
• Battery performance will degrade over time. If an
older battery does not perform as intended without
any obvious explanation, you should consider
exchanging it to a new one.
1. Connect the plug of the charger to the power supply.
3. Push the battery pack in place and make sure the
red light on the charger is "ON". The battery pack is
now starting the charging cycle.
4. After finishing the charging cycle, the light will turn
into green. The battery pack is now ready for use.
1. Switch off the main
switch
2. Press the battery
button. Remove the
battery pack.
3. Remove the strip
of C-rings from the
magazine.
4. Remove the
jammed C-ring by use
of needle-nose pliers.
2. Slide the battery
pack into the charger
in the shown direc-
tion.