Troubleshooting; Tool Led - TJEP C-RINGER Instructions D'utilisation Et De Sécurité

Trouble shooting

Tool LED

State
1 Power on – tool ready for use.
Tool is off, even though main switch
2
is on.
3 Over current protector activated.
4 Motor temperature protector activated.
5 Low voltage failure.
6 Other problems.

Troubleshooting

Problem
Inner diameter of closure is
too big
Inner diameter of closure is
too small
10
State of tool LED indicator
LED indicator
ON
OFF
Flashes
On 0.2 sec
Off 0.2 sec
Flashes
On 0.3 sec
Off 1.5 sec
Flashes
On 0.8 sec
Off 0.8 sec
Flashes
On 0.2 sec
Off 0.2 sec
Cause
Latch is damaged
Latch spring damaged
Insufficient tool power
1. Lack of battery power
2. Lack of lubrication
Jaws damaged
(C-ring groove or bolt hole)
Jaw bushing or roller
damaged
C-ring problem
1. Wire is too hard
2. Surface too rough
3. Burr in cut section
Jaws damaged
Remarks
Tool switches to sleep mode 1 min. after last
actuation.
Actuate the trigger and the tool will start again.
Switch off main switch and turn on the tool again.
To avoid over current, make sure to use the use
the right tool for the right work piece diameter.
Switch off main switch and let the tool cool down.
Be sure that tool is clean and properly lubricated.
Insufficient power supply. Replace/charge battery
pack.
Switch off main switch and turn on the tool again.
If the problems reoccur, please contact your TJEP
dealer.
Corrective action
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair
1. Charge/replace battery
2. Clean and lubricate tool
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair
Use good quality C-rings
Contact your TJEP dealer for repair