TJEP C-RINGER Instructions D'utilisation Et De Sécurité page 11

C-ring front tip cannot locate
in the groove of jaws
Closed shape is not correct
C-ring jam
Jaws damaged
Upper and lower jaws not
aligned.
The C-ring groove of jaws is
damaged.
C-ring problem
1. Wire too hard
2. Surface too rough
3. Burr in cut section
Latch damaged
Latch spring deform or
damaged
Contact surface between
side plate and latch
damaged
Feeder blade damaged
C-ring problem
1. Wire too hard
2. Surface too rough
3. Burr in cut section
Magazine assembly worn or
damaged
Pusher damaged
Pusher spring assembly
damaged.
Feeder blade damaged.
C-ring groove of jaws
damaged.
C-ring problems:
1. Burr on surface of C-ring
2. Crooked strip
3. Uneven strip
4. Bent or deformed C-rings
5. Asymmetry
6. Bad adhesion of collation
tape (C-rings fall off)
Wrong type of C-rings
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair
Use good quality C-rings
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair
Use good quality C-rings
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair
Contact your TJEP dealer for repair
Use good quality C-rings
See C-ring specification
English
11