Sound Adjustments; Setting V-Chip - Toshiba 20A42 Mode D'emploi

SOUND ADJUSTMENTS

Sound controls are factory preset but you can adjust them
individually as follows:
To display sound adjustments on the screen, press MENU.
Press SET + or – to select the AUDIO option, then press ENTER.
BASS
Press ENTER until "BASS" appears on the screen, then press
SET + or – to adjust the bass sound.
TREBLE
Press ENTER until "TREBLE" appears on the screen, then
press SET + or – to adjust the treble sound.

SETTING V-CHIP

This TV is fitted with a V-CHIP controller that provides you with channel viewing access controls and restrictions. This function is to
prevent your children from watching violent or sexual scenes that you may choose to exclude.
1 Press MENU and press SET + or – until the indicator next
to "V-CHIP SET" begins to flash, then press ENTER.
2
Enter your password (4 digits) using the Direct channel
selection buttons (0-9).
In the event of entering an incorrect password press
RESET. Then press ENTER.
3
Enter the same password for confirmation, then press
ENTER.
4
Press SET + or – until the indicator next to "V-CHIP"
begins to flash.
Press ENTER to select ON.
5
Press SET + or – until the indicator next to "TV RATING" or
"MPAA RATING" begins to flash. Press ENTER.
6
Press SET + or – to select the desired rating for the
applicable video or TV channel. Press ENTER.
7
Press MENU repeatedly until the MENU screen is cleared.
NOTES:
• V-Chip function is based on specifications for the United States and therefore may not work properly in Canada.
• If you want to change your password, follow steps 1 and 2 and select "CHANGE PASSWORD" option. Then enter your new
password.
• The V-Chip function is activated only on programs and tapes that have the rating signal.
• Once you block a program using the V-Chip function, the blocked program cannot be watched based on the content of the show.
When the program starts, the "INPUT PASSWORD" will appear on the screen. When you want to release the V-Chip
temporarily, enter the password.
If you change the channel or turn off the TV while the V-Chip function was temporarily released, the original setting will be
resumed. If you return to the channel you were watching you must re-enter your password to temporarily release your V-Chip
function again.
• When you watch the TV using a cable box or a VCR and the TV is tuned to channel 3 or 4, you must release the V-Chip
temporarily. The V-Chip setting will not be resumed until you turn off the TV. The TV channel is not used in this case.
• When changing the channel with the cable box or the VCR, approximately 10 seconds will pass until the program appears.
10
3L70101A-E P.08-13 10
BALANCE
Press ENTER until "BALANCE" appears on the screen, then
press SET + or – button to obtain an equal sound level from
both speakers.
RESET
Pressing RESET while making sound adjustments will
return all adjustments to the factory preset levels.
NOTE:
The on-screen display will disappear 6 seconds after
finishing an adjustment. The settings can only be
adjusted when they are displayed on the TV screen.
TV RATING
SET –
OFF TV-Y TV-Y7 TV-G
TV-Y : all children
TV-Y7 : 7 years old and above
TV-G : children's program
When you select TV-Y7, TV-PG, TV-14 or TV-MA, press RECALL to
explain the rating.
Press the SET + or – to select the desired rating you want. Press ENTER
to select the setting ON or OFF.
MPAA RATING
SET –
OFF G PG PG-13
G : all ages
PG : parental guidance
PG-13 : parental guidance less NC-17
than 13 years old
5/6/02, 11:34 AM
SET +
TV-PG TV-14 TV-MA
TV-PG : parental guidance
TV-14 : 14 years old and above
TV-MA : 17 years old and above
SET +
R NC-17 X
R : under 17 years old parental
guidance suggested
: 17 years old and above
X : adult only