Fcc Notice - HME ISC HD Instructions D'utilisation

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communication. Operation of this equipment in
a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own
expense.
Changes or modifications not expressly approved by HM Electronics, Inc. could void the users authority to operate this equipment.
MANDATORY SAFETY INSTRUCTIONS FOR INSTALLERS AND USERS
Use only manufacturer supplied or authorized antennas.
The Federal Communications Commission has adopted a safety standard for human exposure to RF (Radio Frequency) energy, which
is below the OSHA (Occupational Safety and Health Act) limits.
Base Station Antenna gain: This device has been designed to operate with an antenna having a maximum gain of up to 2dBi. The
required antenna impedance is 50 Ohms.
Antenna mounting: The antenna(s) used for the base transmitter must be installed to provide a separation distance of at least 7.9 inches
(20 cm) from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
Antenna substitution: Do not substitute any antenna for the one supplied or authorized by the manufacturer. You may be exposing
person or persons to excess radio frequency radiation. You may contact your radio dealer or the manufacturer for further instructions.
WARNING: Maintain a separation distance from the base station transmit antenna to a person(s) of at least 7.9 inches (20 cm).
You, as the qualified end-user of this radio device must control the exposure conditions of bystanders to ensure the minimum separation
distance (above) is maintained between the antenna and nearby persons for satisfying RF exposure compliance. The operation of this
transmitter must satisfy the requirements of Occupational/Controlled Exposure Environment, for work-related use. Transmit only when
person(s) are at least the minimum distance from the properly installed, externally mounted antenna.
IC Notice to Users English/French in accordance with RSS GEN Issue 3
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Cet appareil est conforme avec Industrie Canada RSS standard exempts de license (s). Son utilization est soumise à Les deux
conditions suivantes : (1) cet appareil ne peut pas provoquer d'interférences et (2) cet appareil doit accepter Toute interférence, y
compris les interférences qui peuvent causer un mauvais fonctionnement du dispositif.
This device complies with Health Canada's Safety Code 6 / IC RSS-210. The installer of this device should ensure that RF radiation
is not emitted in excess of the Health Canada's requirement. Information can be obtained at:
radiation/radio_guide-lignes_direct-eng.php
Cet appareil est conforme avec Santé Canada Code de sécurité 6 / IC RSS-210. Le programme d'installation de cet appareil doit
s'assurer que les rayonnements RF n'est pas émis au-delá de l'exigence de Santé Canada. Les informations peuvent être obtenues :
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct-eng.php
Hereby, HM Electronics, Inc., declares that ISC HD, regulatory model 1406, is in compliance with the essential requirements and other
relevant provisions of Radio Equipment Directive 2014/53/EU.

FCC NOTICE

http://www.hc-sc.gc.ca/ewh-semt/pubs/