Remote Control Unit - Samsung DVD-R135 Manuel D'instructions

HDMI output Jitter
Check your TV system setup
Checkpoint 1
correctly.
Screen Jitter may occur when the
Checkpoint 2
frame rate is converted from 50Hz to
60Hz for 720p/1080i HDMI (High
Definition Multimedia Interface)
Output.
Please refer to the user's manual of
Checkpoint 3
your TV.

Remote Control Unit

The remote control doesn't work.
Point the remote control at the remote
Checkpoint 1
control sensor on your DVD recorder.
Allow for proper distance. Remove
obstacles between your DVD recorder
and the remote control.
Checkpoint 2
Check whether the batteries are
empty.
94 - English
Other
I forgot my password for parental supervision.
Press the (
Checkpoint 1
your DVD recorder simultaneously
when the power is on. All settings
including the password will revert to
the factory settings. Do not use this
unless absolutely necessary.
(Note that this function is possible only
when no disc is inserted.)
Is it possible to change a subtitle and an audio
signal on a recorded disc?
A recorded disc is played with only
Checkpoint 1
the subtitle and the audio signal
which were selected during recording.
Other problems
Read the table of contents and then
Checkpoint 1
find and read the section describing
your problem, and follow the
instructions given.
Turn your DVD recorder off and on.
Checkpoint 2
Checkpoint 3 If the problem still persists, contact a
nearby Samsung service center.
) and ( ) buttons on