Installation; Points To Be Considered When Re-Transporting Your Refrigerator; Before Operating Your Refrigerator; Electric Connection - Beko SSE 26006 Mode D'emploi

3

Installation

B
Please remember that the manufacturer
shall not be held liable if the information
given in the instruction manual is not
observed.
Points to be considered
when re-transporting your
refrigerator
Your refrigerator must be emptied and
1.
cleaned prior to any transportation.
Shelves, accessories, crisper and etc.
2.
in your refrigerator must be fastened
securely by adhesive tape against any
jolt before repackaging.
Packaging must be tied with thick tapes
3.
and strong ropes and the rules of
transportation printed on the package
must be followed.
Please do not forget...
Every recycled material is an indispensable
source for the nature and for our
national resources.
If you wish to contribute to recycling
the packaging materials, you can
get further information from the
environmental bodies or local
authorities.
Before operating your
refrigerator
Before starting to use your refrigerator
check the following:
Is the interior of the refrigerator dry and
1.
can the air circulate freely in the rear of
it?
Please install the 2 plastic wedges as
2.
illustrated in the figure. Plastic wedges
will provide the required distance
between your refrigerator and the wall
in order to allow the air circulation. (The
illustrated figure is only an example
and does not match exactly with your
product.)
Clean the interior of the refrigerator as
3.
recommended in the "Maintenance
and cleaning" section.
Plug the refrigerator into the wall outlet.
4.
When the fridge door is open, the
fridge compartment interior light will
come on.
You will hear a noise as the compressor
5.
starts up. The liquid and gases sealed
within the refrigeration system may
also give rise to noise, even if the
compressor is not running and this is
quite normal.
Front edges of the refrigerator may feel
6.
warm. This is normal. These areas
are designed to be warm to avoid
condensation

Electric connection

Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
• The connection must be in compliance
with national regulations.
• The power cable plug must be easily
accessible after installation.
• The specified voltage must be equal to
your mains voltage.
• Extension cables and multiway plugs
must not be used for connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated before it
is repaired! There is danger of electric
shock!
8
EN