Black & Decker ACCU-TRAK SAW SCS600 Manuel D'instructions page 6

Use the appropriate blade for material being cut:
Laminates - Use a fine tooth blade
Wood - Use appropriate wood cutting blade for desired finish.
Metal - Use a finer blade for ferrous metals (for those that have a high iron content); and
use a coarser blade for nonferrous metals (those that do not have an iron content).
CAUTION: Do not touch used blades, they may be hot. Personal injury may result.
SMART SELECT DIAL (FIGURES D1, D2 & E)
The Smart Select Dial is used to control orbit, straight cut guide and handle positions of
the saw.
The saw has two settings:
1.) Straight cutting in wood (figure D1).
In this cutting mode, the straight cutting
guide is projected under the shoe and rides
in the sawʼs cutting path to keep the saw
straight.
Blade orbital action is on.
NOTICE: Check alignment of straight cutting
guide before each use.
2.) Curved or straight cutting in all other
materials (wood, metal, pvc, etc. (figure D2))
In this mode, the guide is retracted and the
blade orbital action is off.
CHANGING THE SMART SELECT DIAL (FIGURE E)
WARNING: Turn off and unplug the tool
before making any adjustments or
removing/installing attachments or
accessories.
- To change the dial, grasp and turn as
shown.
- As the dial is turned, the shoe position
relative to the saw will adjust.
All manuals and user guides at all-guides.com
6
D1
D2
E