ESTEBAN EASY LIVING Notice D'utilisation page 9

Diffuseur brume de parfum
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
REPAIR
If the product is not working properly, check the following points:
Problems / Symptoms
No mist when the
appliance is switched on
Mist stops while the
diffuser is in operation
Insufficient mist
The light does not
this risks
switch on
Should the problems persist please contact your retailer.
The manufacturer is not responsible for damages caused by improper use of the diffuser.
for it use
se aerosol
dry cloth.
Input adapter
ept fabric
Output adapter
aking sure
Power
CMP-186_Notice-DiffuseurEasyLiving_04-22.indd 9
CMP-186_Notice-DiffuseurEasyLiving_04-22.indd 9
Causes
The appliance is not plugged in
Water level too low
Water level exceeds 200 ml
The end of part A is obstructed
Water level too low
Accumulation of water drops in the part A
The ceramic disk is dirty
An excess of Estéban refresher oils has been
poured into the container
Accumulation of water drops in the part A
Diffuser failure
100-240V
50/60Hz
24V
0.5 mA
7,5 W
Solutions
Make sure that the power adapter is properly connected to
the appliance and fully plugged in to the wall socket
Fill the water container
Empty out excess water
Make sure that nothing is preventing the release of the mist
Fill the water container
Switch off the diffuser, remove part A then clean off the
accumulated water drops
Clean the ceramic disk as described in the «PRECAUTION
FOR USE» instructions
Empty the appliance and clean it
Switch off the diffuser, remove part A then clean off the
accumulated water drops
Bring the diffuser back to the retailer within the after-sales
service support legal deadline
9
22/04/2022 14:59:15
22/04/2022 14:59:15

Publicité

Table des Matières
loading

Table des Matières