CAME G4040EZ Manuel D'installation page 46

Command and control devices
Transponder or card reader
Keypad selector
OPEN-CLOSE-INVERT (step-by-step) function from
control device (N.O. contact).
CLOSE function from control device (N.O. contact).
Warning: in HOLD-TO-RUN mode, the control device must
be connected to 2-4.
Warning! OPEN function from control device (N.O.
contact), to be connected only for paired or alternate
systems. (See PAIRED or ALTERNATE CONNECTION)
OPEN function from control device (N.O. contact).
Warning: in HOLD-TO-RUN mode, the control device
must be connected to 2-3.
STOP button (N.C. contact). For stopping the boom while
excluding automatic closing. To resume movement either
press the control button or any other control device.
 If unused, select 0 (Disabled) from the function F 1.
 Insert the decoding card (R800)
so that the keypad selector is
recognised.
WARNING! Before inserting any plug-in card (e.g. AF, R800), LINE VOLTAGE MUST BE DISCONNECTED. If installed, disconnect the batteries.
Antenna with RG58 cable
 Insert the AF card to control the
barrier via a transmitter.
M E
C A
 Insert the decoding card (R700) for the
TSP00 sensor or LT001 card reader to be
recognised.
Black
Red
Blue
White
A B GND A B S1 GND