Kicker KMA150.2 Manuel D'utilisation page 8

No or low output?  Check the balance control on source unit  Check the RCA (or speaker input)
and speaker output connections.  Check for reversed polarity at the speaker(s)
Alternator noise-whining sound with engine's RPM?  Check for damaged RCA (or speaker input)
cable  Check the routing of RCA (or speaker input) cable  Check the source unit for proper grounding
 Check the gain settings and turn them down if they are set too high.
Ground Noise? KICKER amplifi ers are engineered to be fully compatible with all manufacturers' head
units. Some head units may require additional grounding to prevent noise from entering the audio signal.
CAUTION: When jump starting the battery, be sure that connections made with jumper cables are
correct. Improper connections can result in blown amplifi er fuses as well as the failure of other critical
systems in the boat.
If you have more questions about the installation or operation of your new KICKER product, see the
Authorized KICKER Dealer where you made your purchase. For more advice on installation, click on the
SUPPORT tab on the KICKER homepage, www.kicker.com. Choose the TECHNICAL SUPPORT tab,
choose the subject you are interested in, and then download or view the corresponding information.
Please E-mail support@kicker.com or call Technical Services (405) 624-8583 for unanswered or specifi c
questions.
KMA150.2
40 x 2 @ 4 ohms, 14.4VDC, 1% THD, CEA-2006B (Watts)
Signal to Noise Ratio -75dB CEA-2006B (ref: 1W, A-weighted)
KMA300.4
40 x 4 @ 4 ohms, 14.4VDC, 1% THD, CEA-2006B (Watts)
Signal to Noise Ratio -75dB CEA-2006B (ref: 1W, A-weighted)
KMA450.6
40 x 6 @ 4 ohms, 14.4VDC, 1% THD, CEA-2006B (Watts)
Signal to Noise Ratio -75dB CEA-2006B (ref: 1W, A-weighted)
8
2018 KMA MultiChannel Amps Rev D.indd 8 2018 KMA MultiChannel Amps Rev D.indd 8 10/12/2017 5:24:22 PM 10/12/2017 5:24:22 PM