K2 Pumps SWW05002TPK Notice D'utilisation page 5

2. Place pump securely to the solid surface such as a cement block in the basin.
3. Connect the discharge pipe (1) to the elbow (2), check valve (3), and gate valve (4).
Plug the switch plug into a 115V GFCI power outlet.
Electrical
WARNING:
Risk of electric shock. Can shock, burn or kill. When installing, operating, or servicing this pump,
follow safety instructions listed below.
1. DO NOT splice the electrical power cord.
2. DO NOT allow electrical cord plug to be submerged.
3. DO NOT use extension cords. They are a fire hazard and can reduce voltage sufficiently to prevent pumping and/or
damage motor.
4. DO NOT handle or service pump while it is connected to power supply.
5. DO NOT remove grounding prong from plug or modify plug to protect against electrical shock, the power cord is a
three-wire conductor and includes a 3-prong grounded plug. Plug pump into a 3-wire, grounded, grounding type
receptacle. Connect pump according to electrical codes that apply.
For automatic operation, plug or wire pump into the automatic float switch. Pump will run continuously when plugged
directly into an electrical outlet. Connect or wire pump to an individual branch circuit with no other outlets or equipment in
the circuit.
Size fuses or circuit breakers according to chart below.
For Professional Technical Support call 1-844-242-2475 5