Panasonic EY4550 Instructions D'utilisation page 8

Position of base and purpose of use
Base adjustment
hole position
NOTE:
This is only a rough guide. The
actual angle of the cut will be
affected by factors such as the way
the tool is held against the surface.
Purpose of use
Normal right-angled
cutting
Cutting at an angle
between 0° and 45°
Adjusting the orbital stroke mode
• Adjust the orbital stroke mode to the
object to be cut.
Lever
position movement
0
Vertical only
1
Low orbital stroke
2
Medium orbital
stroke mode
3
High orbital
stroke mode
• If you would like to produce a cleaner
finish, set the orbital stroke mode to
a lower level.
- 8 -
3
2
1
Blade Main
applications
• Cutting hard
metals such as
steel
• Smooth cutting of
building materials
and plywood
boards
• Cutting around
small curves
• Cutting softer
metals such as
aluminum and
other non-ferrous
metals
• Cutting hardwood,
plywood boards
and plastics
mode
• Cutting fairly soft
materials
• Cutting wood and
composite boards
• High-speed
cutting of
aluminum and soft
steel
• Cutting soft
materials
• High-speed
cutting of
materials such as
wood, composite
boards and
plastics