Power Switch - Velodyne CHT-8R Mode D'emploi

You should set the crossover frequency to obtain a smooth and
seamless transition from the subwoofer to the main speakers in your
system. If your main speakers are smaller units with limited low
frequency output, you may wish to choose a higher frequency (such
as 100-120 Hz) than you would with larger speakers which have
greater low frequency output. With larger speakers, you might start
with this control set lower, such as 80 Hz.
Subwoofer Direct
Subwoofer Direct is a setting on the low-pass crossover knob and
will allow frequencies up to 200 Hz into the subwoofer. See below
for a more detailed explanation of this feature.
Speaker Level Output/Line Level Output
When connected in this fashion, your satellite speakers will be
crossed over at 80 Hz. This removes the lower bass from your
satellites, enabling them to do a better job reproducing high
frequencies and giving your receiver's amp more headroom (up to
50% more power).
You may also connect your satellites directly to your receiver or
amplifier along with the subwoofer if you wish to bypass this
crossover.
Caution!!!
To avoid damage to your main amplifier, be sure to maintain correct
polarity when making all connections. Red (positive) to red, and
black (negative) to black. Be sure that all connections are tight, and
that there are no loose strands or frayed wires.

Power Switch

The master power switch is located on the lower right half of the unit.
This rocker style switch is the main on/off for the unit. This switch
should be set to position 1 for on (up), 0 for off (down).
A Word About Your Receiver's Crossover and the CHT-R
Crossover
Your Velodyne CHT-R subwoofer is designed to operate using the full
range audio signal for input when using the built-in crossover (controlled
by the dial on the back panel). Many home theater processors/receivers
® ® ®
(Dolby Digital , DTS , THX ) have a "subwoofer out" jack that performs
continued. . .
6