LG LW-C1262QC Manuel Du Propriétaire page 10

All manuals and user guides at all-guides.com
Installation Instructions
Install the Air Conditioner in the Case
A
Slide the air conditioner into the case.
Reinstall the screws removed earlier on
each side of the case.
Screw
CAUTION: The power cord must be connected to
an independent circuit breaker.
The Green/Green-Yellow wire must be grounded.
B
Stuff the foam between the unit and the
wall to prevent air and insects from getting
into the room.
C
Before installing the front grille, pull out the
vent control lever located above the unit
control knobs, as shown.
Use the Reversible Inlet Grille (Optional)
A
If you want to pull out the filter upward, open the inlet grille slightly.
Turn inside out the front grille.
Disassemble the inlet grille from the front grille with separating the
hinged part by inserting a " " type screw-driver tip.
Rotate the inlet grille 180 degrees and insert the hooks into the
lower holes of front grille.
Then, insert the filter
B If you want to pull out the filter downward, use the reversible inlet
grille without change (The grille is already assembled for that way.)
D
Power Cord
Screw
The Foam
E
-10-
Attach the front grille to the case by
inserting the tabs on the grille into the slots
on the front of the case. Push the grille in
until it snaps into place.
When you detach the
front grille from the
case, push the grille
to your right side and
pull it toward you.
Lift the inlet grille and secure the front grille
with a screw. Lower the inlet grille into
place.