Prior To Operation - DeWalt DW803 Traduction De La Notice D'instructions Originale

Mounting and Removing the Guard
(fi g. 2)
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.
TO MOUNT THE GUARD
1. Align the lugs (e) on the guard with the slots (f)
in the bracket located on the gear case (fig. 2a).
2. Press the guard down towards the gear case
and rotate the guard in the direction of the
arrow (fig. 2b).
3. The guard locking pin (g) prevents the guard
from loosening while allowing the guard to
rotate 105˚.
TO REMOVE THE GUARD
1. Place the tool upside down on a flat surface.
2. Hold the tool in your hand and rotate the guard
in the direction of the arrow with your thumb
(fig. 2c). At the same time, using a screwdriver
or other pointed instrument, press the locking
pin in the slot so that the lug on the guard
comes into view (fig. 2d).
3. The guard, no longer held by the locking pin,
can be pushed free by thumb pressure.
WARNING: Never use the tool without
the guard in place.
NOTE: Please refer to the Grinding Accessory
Chart at the end of this section to show other
accessories that can be used with these grinders.
Fitting and Removing a Grinding Disc
(fi g. 3, 4)
WARNING: Do not use a damaged
disc.
1. Place the tool on a table, guard up.
2. Fit the inner flange (h) correctly onto the spindle
(i) (fig. 3).
3. Place the disc (j) on the flange (h). When fitting
a disc with a raised center, make sure that the
raised centre (k) is facing the flange (h).
4. Screw the outer flange (l) onto the spindle (i)
(fig. 4). The ring on the flange (l) must face
towards the disc when fitting a grinding disc.
5. Press the spindle lock (b) and rotate the spindle
(i) until it locks in position.
6. Tighten the flange (l) with the two-pin spanner
supplied.
7. Release the spindle lock.
8. To remove the disc, loosen the flange (l) with the
two-pin spanner.

Prior to Operation

• Install the guard and appropriate disc or wheel.
Do not use excessively worn discs or wheels.
• Be sure the inner and outer flange are mounted
correctly.
• Make sure the disc or wheel rotates in the
direction of the arrows on the accessory and the
tool.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.
WARNING:
• Ensure all materials to be ground are
secured in place.
• Apply only a gentle pressure to the
tool. Do not exert side pressure on the
disc.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Proper Hand Position (fi g. 1, 7)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
ENG L IS H
9