Cameo F4 D PO IP Manuel D'utilisation page 8

DEVICE SETTINGS (Settings)
Press the encoder to access the main menu. Rotate the encoder to select the menu item "Settings" (left arrow) and confirm by pushing the
encoder. This will take you to the submenu for setting the submenu items (see table, rotate the encoder to select and push the encoder to
confirm selection). Now select the arrow symbol for "back" at the top of the submenu. Push the encoder and access the main menu in the
same way to return to the main display.
---------------- Menu ----------------

DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
Settings
Display Reverse = Flip display
Display Backlight = Display lighting
DMX Fail = operating status
with DMX signal
fault
Dimmer Curve = dimmer curve
Dimmer Response = Dimmer response
LED PWM = LED PWM
Frequency frequency
8
 Back
On Rotate display by 180° (e.g. for overhead installation)
Off No display rotation
 Back
On On permanently
Off Deactivation after approximately 1 minute of inactivity
 Back
Hold Last command is retained
Blackout Activates blackout
Full On Spotlight switches to full on
Stand Alone Spotlight switches to stand-alone mode
 Back
Linear Light intensity increases linearly with DMX value
Exponential Light intensity can be finely adjusted at lower DMX values and
broadly adjusted at higher DMX values
Logarithmic Light intensity can be broadly adjusted at lower DMX values and
finely adjusted at higher DMX values
S-Curve Light intensity can be finely adjusted at lower and higher DMX
values and broadly adjusted at medium DMX values
Back

LED Lamp responds abruptly to changes in DMX value
Halogen Lamp behaves like a halogen spotlight with soft brightness
changes
 Back
800Hz / 1200Hz / Configuration of LED PWM frequency
2000Hz / 3600Hz /
12kHz / 25kHz