Introduction - Cameo F4 D PO IP Manuel D'utilisation

32. The device must only be installed in a voltage-free condition (disconnect the mains plug from the mains).
33. Dust and other debris inside the unit may cause damage. The unit should be regularly serviced or cleaned (no guarantee) depending on
ambient conditions (dust etc., nicotine, fog) by qualified personnel to prevent overheating and malfunction.
34. Please keep a distance of at least 0.5 m to any combustible materials.
35 Use only the supplied power cable to connect the device to the mains power supply.
The warning triangle with lightning symbol indicates dangerous uninsulated voltage inside the unit, which may cause an
electrical shock.
The warning triangle with exclamation mark indicates important operating and maintenance instructions.
Warning! This symbol indicates hot surfaces. Specific housing parts can become hot during operation. Allow the device to cool
for at least ten minutes after use. Only then can it be transported or touched.
Warning! This device is designed for use below 2000 metres in altitude.
Warning! This product is not intended for use in tropical climates.
Caution! Intense LED light source! Risk of eye damage. Do not look into the light source.
CAUTION! IMPORTANT INFORMATION ABOUT LIGHTING PRODUCTS!
1. Do not stare, even temporarily, directly into the light beam.
2. Do not look at the beam directly with optical instruments such as magnifiers.
3. Strobe effects may cause epileptic seizures in sensitive people! People with epilepsy should definitely avoid places where
strobe effects are used.

INTRODUCTION

CONTROL FUNCTIONS
1-channel, 2-channel 1, 2-channel 2, 3-channel, 4-channel and 5-channel DMX control
Master/Slave operation
Standalone functions
FEATURES
IP65 protection rating. 14°–43° beam angle, manual zoom. Adjustable pole-operated pan, tilt, and zoom. 250 mm Fresnel lens. Configurable
PWM frequency (flicker free). DMX-512 control. RDM enabled. Manual control. 4 dimmer curves. 16 bit dimming. Master/slave mode.
Extremely quiet operation thanks to heat pipe cooling and IP65 fan. Operating voltage: 100–240 V AC / 50–60 Hz.
Power consumption: 460 W. Mounting bracket, filter frame, and 8-way barn door included.
LIGHT SOURCE CLF4DPOIP
1 x high-power 520 W daylight LED.
LIGHT SOURCE CLF4TPOIP
1 x high-power 520 W Tungsten LED (warm white).
Both spotlights feature the RDM standard (remote device management). Remote device management allows the user to view status and
configuration of RDM terminals via an RDM-capable controller.
4
CAUTION:
To reduce the risk of electric shock, do not remove cover (or back). There are no user serviceable parts
inside. Maintenance and repairs should be exclusively carried out by qualified service personnel.